|
|
 |
 |
PC-3000 Flash, version 1.5.0
It has become much more automatic, functional and efficient.
Changes and the additions for 1.5. version of PC-3000 Flash software.
1. One of the basic changes in version 1.5. is the mode of automatic determination of the necessary sequence of operations to prepare the results of task for the analysis and the execution of this sequence.
2. The mode consists of the following elements:
- automatic determination and the elimination of mixing through the bytes in the initial results of reading or of the results of preliminary preparation;
- automatic determination and the elimination of inversion in the initial results of reading or in results of preliminary preparation;
- the automatic determination of the nonstandard structure of the task sector in the initial results of reading or the results of preliminary preparation and bringing them to the standard form. As the standard form within the framework of PC-3000 flash, the size of page 512 + 16. is considered;
- automatic determination and the elimination of the characteristic "Interleave" in the initial results of reading or in the results of preliminary preparation;
- the automatic determination of the need for additional conversions in the initial results of reading or the results of preliminary preparation and the fulfillment of these operations;
- the complex mode, which includes the above-enumerated operations in the specific sequence with the automatic fulfillment of all necessary operations.
The elements of mode are accessible for the individual fulfillment in the group "Methods of study". For the application towards the result, it is necessary to isolate it in the group "Results of preliminary preparation" or in the group "Microcircuits of memory", if it is necessary to apply method to the initial dumps. The methods of this group make possible to estimate the need of fulfilling various operations with the preparation of task for the direct fulfillment of analysis.
In this version the described mode is combined with the mode of Autodetermination, which considerably enlarges the possibilities of earlier one. In this case the list of the carried out operations can be changed by necessity with the mode's starting.
If the method "Restorations by the controller" did not yield positive results, or the required controller did not prove to be in the base of complex, you should start the mode of Autodetermination on the group "Microcircuits of memory" immediately after the reading of all microcircuits of task.
Data collection mode also includes the elements of the mode of the automatic determination of the necessary operation sequence for the preparation of the results of task for the analysis, this made possible to increase authenticity and quality of gathered information.
After the completion of data collection mode the obtained result remains in the folder "Collection of information" in the tree of the task results.
It can be arbitrarily removed or transmitted to specialized FTP any moment by PC-3000 Flash itself.
To do this you need to mark the necessary result of the collected data and select in the falling out menu point "Send to FTP". The parameters FTP communicate individually with reach other after Technical Support Service has obtained those letters with the indication of the size of the extracted file.
Other additions and the change:
- error in method "Number of block type 0 [0000]"is corrected;
- the possibility to use a mask in the method "Number of block type 0 [0000]" is added;
- method "Translator the type of 3 MemoryStick" is completed;
- the mode of auto-analysis is improved. Now it is carried out more rapid and it is more reliable;
- the mode of the data collection is changed. Its effectiveness is increased.;
- new controllers are added in the base of PC-3000 Flash.
|
|
|
|
 |
|
|
|
|
